What is contained in AC installation?

What is contained in AC installation?

Blog Article

The installing of the split air conditioners is an essential job. If the installation is done accurately your air conditioning will give optimum cooling, but if it's not done properly you won't get the desired cooling effect. An undesirable installations also leads to frequent maintenance problems.

Several factors need to considered during the installing split air conditioner.
1. Strength of wall to put up the AC

The indoor unit of split AC should be installed on a wall strong enough to put up the unit's weight.
2. Proper spacing between wall and AC unit

The indoor unit of split AC requires at least 15 cm of open space surrounding its top and sides for proper air flow.
3. Appropriate installation height from ground

Mount the indoor unit of split AC at a height of 7-8 feet above the bottom for adequate cooling inside the area
4. Correct tilt angle of indoor unit

While fixing the aluminum bracket on wall make sure that the bracket is given a slight tilt angle, so the indoor unit of split AC, when fitted is also at a slight angle to enable unrestricted flow of the condensed water from the drain pipe.
5. Correct location of outdoor unit

For proper cooling, mount the indoor and outdoor units of split AC at location away from direct sunlight and water. Install the outdoor unit of split AC in open space so that there is no hindrance to heat dissipated from the condenser.

6. Proper keeping of outdoor unit

The outdoor unit of split AC must be positioned on a flat and rigid surface. This unit contains key components of split AC like compressor, condenser, fan motor etc. If the system isn't on a flat work surface then it'll vibrate excessively, which can cause the breakage of copper pipes, coolant leakage and compressor/condenser damage. Further, the vibrating unit makes lots of noise which could disturb you and your neighbors.

Click here www.premierairandheat.com to get more information about ac installation orlando fl.

Report this page